Hand-operated conduit punch and die set for cutting neat conduit entries in metal panels, Uxcell Conduit Punch and Die Set. Tradespeople gain a portable tool that keeps site work tidy and reduces reliance on power tools. Is it robust enough for repeated use on thicker metals?
⚡ At a Glance
- • Cutting Quality: Clean 43mm holes with minimal burrs and accurate fit
- • Best for: Electricians, installers and fabricators needing neat conduit entries in metal panels
- • Not ideal for: Jobs requiring hole sizes other than 43mm without additional dies
Manual knockout punch set designed for 43mm conduit holes. Heat-treated 40 chromium steel construction aims to resist wear and handle stainless steel, iron and aluminium.
Accurate 43mm cuts, with matched punch and die
Matched upper and lower die geometry centres the cut, using a 43mm conduit punch with complementary die dimensions for guided shearing. The lower die and upper die inner diameters align to produce a consistent hole profile.
Neat conduit entries reduce finishing work and speed installation, ideal where tidy panel work matters.
Durable construction, with 40 chromium steel heat treatment
Knockout driver unit made from 40 chromium steel undergoes heat treatment to increase hardness, wear resistance and corrosion protection. The treated steel helps maintain edge integrity under repeated use.
Longer tool life keeps maintenance low and preserves cutting performance across multiple jobs.
Portable and straightforward to use, with simple assembly steps
Operation requires an 11.5mm guide hole, insertion of the draw stud, then sequential placement of lower die, workpiece and upper die before pressing to open the hole. The manual workflow needs no mains power and minimal setup.
Quick on-site setup allows use in restricted areas and helps avoid heavy machinery or extensive preparation.
✨ The 4 Key Reasons for Uxcell Conduit Punch and Die Set
- Heat-treated 40 chromium steel, stays sharp and resists wear across repeated metal-sheet jobs
- Compact manual operation, ideal for tight sites without access to power tools
- Minimal surface damage, produces neat edges that reduce finishing time on panels
- Broad material compatibility, works on stainless steel, iron and aluminium plate
📋 Technical Details at a Glance
- Conduit hole size: 43mm / 1.7"
- Lower die diameter: 54mm / 2"
- Lower die height: 24mm / 0.94"
- Lower die inner hole diameter: 20mm / 0.78"
- Upper die diameter: 39mm / 1.5"
❓ Frequently Asked Questions
Q: What hole size does the set cut?
A: The kit is designed to cut a 43mm conduit hole.
Q: Which materials can be punched with this set?
A: Suitable for stainless steel, iron and aluminium, among other metal panels.
Q: How do I start using the punch and die set?
A: Open an 11.5mm guide hole, screw in the draw stud, place the lower die, the workpiece, and the upper die in sequence, then press to open the hole.
🏆 Our Verdict
Ideal for electricians, installers and fabricators who need tidy conduit entries in metalwork. Robust heat-treated 40 chromium steel and matched punch and die geometry deliver durable, clean cuts across several metals. Although initial outlay may be higher than a basic cutter, the reduced finishing time and durability make it a sensible long-term workshop investment.
