Automotive replacement part designed to restore steering control and alignment, GOOFIT Tie Rod End. Peace of mind for home mechanics and racers tackling a worn steering linkage. Are the 10mm and 12mm bolt widths the right match for your go-kart or quad buggy?
⚡ At a Glance
- • Durability: High-metal construction, described as wear-resistant and high-temperature resistant
- • Best for: Owners of go karts, quad buggies and ATVs needing a steering linkage replacement
- • Not ideal for: Vehicles that require bolt widths other than 10mm outer and 12mm inner
Replacement tie rod end with outer bolt width 10mm and inner bolt width 12mm. Adjustment ball joint includes a taper and uses a clockwise thread for direct replacement.
Long-lasting steering reliability - thanks to high-metal, wear-resistant construction
Manufacture described as high metal material, with explicit wear resistance and high-temperature resistance. Robust metallurgy helps retain component geometry under load and heat.
Improved longevity under frequent use leads to fewer repeat repairs and steadier steering response during aggressive driving or heavy use.
Accurate fit for common small off-road vehicles - with 10mm outer and 12mm inner bolt widths
Outer bolt width specified as 10mm (0.39"), inner bolt width specified as 12mm (0.47"). Measurements match typical tie rod interfaces for many go karts, quad buggies and ATVs.
Correct dimensions allow a direct swap when matching existing hardware, cutting workshop time and avoiding additional adapters.
Easier alignment during installation - with a tapered adjustment ball joint and clockwise thread
Adjustment ball joint is tapered and uses a clockwise thread, designed for straightforward engagement and secure clamping. Tapered joints seat tightly to maintain alignment.
Fine-tuning toe and steering geometry is simpler during refit, helping to restore predictable handling after replacement.
✨ The 4 Key Reasons for GOOFIT Tie Rod End
- Direct replacement fit - Allows quick swap on compatible go karts and ATVs without modifications
- Tapered adjustment ball joint - Enables accurate seating and easier alignment setup
- Clockwise thread - Matches common steering assemblies and simplifies installation orientation
- Wear-resistant construction - Promotes longer service life under demanding conditions
📋 Technical Details at a Glance
- Category: Automotive Parts and Accessories
- Brand: GOOFIT
- Material: High metal material, wear-resistant, high-temperature resistant
- Outer bolt width: 10mm (0.39")
- Inner bolt width: 12mm (0.47")
❓ Frequently Asked Questions
Q: Are these tie rod ends compatible with my go-kart or ATV?
A: Compatibility depends on matching the specified sizes, namely an outer bolt width of 10mm and an inner bolt width of 12mm, and intended use on go karts, quad buggies and ATVs.
Q: What material are the tie rod ends made from?
A: Described as made from high metal material that is wear-resistant and high-temperature resistant for reliable performance and long life.
Q: How difficult is installation and adjustment?
A: Adjustment ball joint with a taper and a clockwise thread is supplied for straightforward installation and alignment during replacement.
🏆 Our Verdict
Suitable for owners of go karts, quad buggies and ATVs who need a straightforward steering linkage replacement. Robust metal construction combined with tapered adjustment and clear 10mm/12mm sizing delivers practical, serviceable steering hardware. Long-term value comes from reduced repeat repairs and simpler installation when sizes match existing assemblies.
